| Back to Product Page |
| grand forks b.c. - Washington |  October 30, 2009 |
tickety-boo
|
| - Connecticut | October 23, 2009 |
The gasket was fine but I could not use this, the motor sat up to high in the vacuum when this was put on.
|
| - South Carolina | October 11, 2009 |
Essential to installation of a new motor on an old system.
|
| Tom M, Yarmouth Port - Massachusetts | August 9, 2009 |
Well packed, arrived quickly and it fit well.
|
| - Maryland |  July 31, 2009 |
The gasket supplied was NOT the same as the original. I did not use the new one.
|
| - Massachusetts | July 19, 2009 |
the gasket was laying over the top of the motor and all deformed it would have been better on top of the box under a piece of cardboard or between the cardboard
|
| Wilmington - North Carolina |  July 5, 2009 |
Gasket was too thin for the Vacuflo vacuum unit that I owned. I had to use the original gasket. Other than that everything was fine.
Bob
|
| Tony, Olathe - Kansas | May 13, 2009 |
Ended up not needing it but it was in-expensive and probably would have needed it if I didn't have it.
|
| - Texas |  April 12, 2009 |
Not needed
|
| - Pennsylvania | March 19, 2009 |
Not as good as the original, which I realized later was easily removed from the old motor I was replacing so I used that.
|
| - Kansas | March 18, 2009 |
Gasket arrived bent up and impossible to remove paper on gasket
|
| Jim Miller, Magnolia - Ohio | March 2, 2009 |
The gasket was easy to install and fit fine.
|
| M Gendron, Salem - New Hampshire | December 29, 2008 |
The parts we received restored our central vac system to good as new condition. Thank you.
|
| - Ohio | December 21, 2008 |
I couldn't use this gasket. I was going to use it when I replaced a motor (Ametek Vacuum motor #115335). This gasket is about .25 inch thick and is too thick for the Vacuflo cover to go back on. I used a bead of clear silicone instead. However, the quality of the gasket looked fine.
|
| B Davidson, Gaithersburg - Maryland | December 11, 2008 |
An unnecessary recommendation by a site for a replacement motor for a VACUFLO 26 central vacuum. (USE ORIGINAL GASKETS as a rule of thumb.)
|
| Peter G. - New Hampshire | November 24, 2008 |
represented and delivered as promised.
|
| Jim S. - Colorado | November 14, 2008 |
Awesome motor Gasket. Maybe the best I've ever used. The adhesive backing stuck and the plastic was completely intact and remained intact during and after the installation. As a gasket aficionado, I can say "well done"
.....yes, I'm kidding.
|
| Ron Tucson - Arizona | October 31, 2008 |
Cannot say the gasket could be used when it arrived. It was crumpled in such a way that it would not lay out flat to be attached to the vacuum unit. In addition the adhesive seemed to be old and no longer sticky to do the job. I sound have returned it, but I used the old gasket and placed new adhesive on it and the old gasket worked perfectly.
|
| - Missouri | October 13, 2008 |
Fit perfect
|
| Bob - New Hampshire | August 29, 2008 |
The gasket was the right outer dimensional size and fit the seating fine even though the width is much smaller than the original old one that came with the unit.
Installation is fairly straight forward and easy.
|
| More Reviews |
