Two Motor Circuit Board 15a 120v

  (4.9/5 Stars) - Overall Rating from 34 Users

Part # P-CB2MTR
Our Price:
$60.27
In Stock

Two Motor Circuit Board 15a 120v

Circuit board for dual motor vacuum units under 16 amps. Will not work with all central vacuums.


For your convenience we have added some articles on how to replace or upgrade your circuit board.


Top Customer Reviews


(5/5 Stars)


September 18, 2023

I used to replace defective relay in Nutone 450 old relay board used 1 relay for both motors new board appears to have 2 relays 1 for each motor, this is my second relay failure, I think this unit with 2 relays should be much moe reliable.

Only problem I had was new female disconnects were 316 inch and motor disconnects were 14 inch I changed motor connections to 316 if I was sure the new unit was going to function correctly I would have changed new relay connections to 14 inch.

So far I am very happy with new circuit board.

- Delaware

(5/5 Stars)


August 12, 2023

Simple replacement and worked great. This board was not a direct replacement for my unit so be advised it may require some rewiring and drilling as mine did, but worked as well as the original once installed and at a fraction of the price of the oem replacement.

-

Ask a Question

Grounded?
Question: How is the 2 motor circuit board grounded? I do not see a ground wire or terminal on the board.....thanks
CVO's Answer:
Correct, this board is not grounded and not required to be grounded under its regulatory procedure.
Compatible With Filtex TS300L?
Question: I wanted to order the two motor circuit board Part # P-CB2MTR. for my Filtex TS300L unit. Your documentation states this board will not work with all central vacuums...can you tell me if your circuit board will work with my unit....thanks
CVO's Answer:
Our circuit boards are not brand specific and may require modifications to the unit (such as drilling an additional hole) for proper mounting. The electronics on the board itself are the same (relay, transformer, mini breaker).
Question: I received the 110v Dual Motor controller and find that the instructions here on the website are not correct for this board. The PCB does not have the labels (LINE, MOTOR, etc.) as listed in the instructions. It has labels like P1, P2, P3, P4, P5, P6. Can you please send me the appropriate instructions? Perhaps you could update the instructions on the web while you're at it. Thanks, Craig Broadbooks
CVO's Answer:

Hello Craig, I will email you directly with the proper wiring diagram. Could you please respond to that email with the link to the incorrect picture on our site, I am unable to find it and would like to send this update to our web department. Thank you!


Not finding the answer you are looking for?
Feel free to ask your question using the form below.

Ask your question below about our 15a-120v-Circuit-Board

We will email our answer to you directly.

Email Address

* Maximum 800 characters.